|
|
|
#1
10-12-2013, 06:34 PM
|
|||
|
|||
Hello
Hello, My name is Isaac, and I make furniture, both custom one off and short run production. I came to this site to learn more about sheet metal and hopefully offer it in my creations. I do not have much sheet metal experience but have just bought a older Di-Acro 36" press brake and plan to use it quite a bit! I have quite a few interests in other types of sheet metal shaping and hope learn them.
thats all for now, thanks! -Isaac 
|
|
#3
10-12-2013, 09:24 PM
|
|||
|
|||
|
Hi Isaac welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
