|
|
|
#1
11-25-2011, 12:19 PM
|
|||
|
|||
Hello, looking forward to learning.
Hello everyone,
My name is Gary and I live just outside Springfield MO in Rogersville about 15 miles away. I love fabrication and have been doing it for a little over 17 years now. I am a machinist/ fabricator by trade running a small shop inside a factory for maintenance support, prototyping, and production. I have a passion for cars and enjoy kustom metalwork and fabrication on them as a hobby that I hope to turn into a full time job someday. As the saying goes "The more you learn the more you realize you don't know" has led me here. In doing research for building an English wheel, a vendor on ebay (slscooters) recommended this site and I thank him much for doing so. I am looking forward to picking your brains and reading, reading, reading all the info I can absorb. I would like to say thanks in advance and I am looking forward to meeting new friends. Sincerely, Gary Kanel 
|
|
#2
11-25-2011, 11:36 PM
|
||||
|
||||
|
Gary, welcome to AllMetalShaping and thanks for the introduction. The site has a lot of information to help you learn how to shape sheet metal. Hope you enjoy the site and find it helpful. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
11-26-2011, 05:04 PM
|
|||
|
|||
|
Welcome to the site Gary
 Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
