|
|
|
#1
11-29-2016, 02:51 AM
|
|||
|
|||
Hello from NW ohio
Hello everyone,
I've dabbled in metal shaping, mostly fabricating VERY crude patch panels for body work. I've recently decided to undertake one of those projects that's always been in the back of my mind and never seemed to happen. I've finally decided its time to make the Mad Max crown vic. I will be making new wheel arches for the rear wheels to provide clearance for the all terrain tires. I also will be making some fake armor for the side windows, either 18 or 20 gauge cold rolled sheet. My ideas for the armor involve a bead roller with a tipping die. My budget is almost non existent, so I was researching different ways to skin the proverbial cat, and wound up here. Bob
__________________
Bob Usually when I'm around metal is getting bent anyway, I may as well figure out how to do it right. 
|
|
#2
11-29-2016, 07:46 AM
|
|||
|
|||
|
Welcome to the forum Bob. There's a lot good info and techniques here.
__________________
Mike
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
