|
|
|
#1
01-06-2014, 10:26 PM
|
|||
|
|||
Newbie
Hello all. My name is Stan Westbrook. I hail from SW Georgia where the Knat is the unofficial state bird. I grew up in industrial construction, pipe work mostly but also ironwork and rough millwright. Settled now and building my dream shop one penny at the time. I have the welder, lathe, mill, and ready to get started on my retirement project, a Bearhawk. Presently building a 40 foot bifold door because I am to cheap to by a factory built unit. It is my intention to use counterweights to open the door so that I don't have to spend the money on a motor and gearbox. We will see how that works out. I look forward to learning from each of you
__________________
Stan Westbrook 
|
|
#3
01-07-2014, 04:09 AM
|
|||
|
|||
|
Hi Stan welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#4
01-07-2014, 01:57 PM
|
||||
|
||||
|
Welcome to the site Stan.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
