Derrol Salmon
 

Hello everyone,

I saw a link posted to this site from MM, so I figured I would stroll over here and check it out.

So far so good. It is nice to see some familiar names here.

I try to do some metalshaping when I can, and I am primarily focused on motorcycle related shaping. I am putting together a Cafe Racer inspired motorcycle, so I am building the tank, seat cowl, fender etc for it.
Most of the shaping I do is sheetmetal, but I intend to transition over to more AL in the near future.

Anyway, I hope to see a lot of metalshaping content and I'll try to contribute when and where I can.

_________________
Derrol Salmon
www.jetfuelmoto.com/garageblog