Greetings from Clarkesville, GA
 

Good afternoon,

Brenton Ellis here, hailing from Clarkesville, GA. I'm currently repairing a 1947 Luscombe 8E under A&P supervision, which involves some basic flat-sheet part replacement, riveting, and powerplant overhaul. Part of the project will involve straightening and repairing the wing tips and cowling, which aren't flat by any stretch of the imagination. I imagine that the learning curve there will be pretty steep.

I have worked for the past 13 years at Quest Aircraft Company (Sandpoint, ID) designing aircraft structures, and am finally starting to get my hands dirty actually working on them.

I have some previous experience in college with welding/brazing/riveting/fabrication, but most of my experience is theoretical rather than practical. In other words, I can design structures but need someone else to make them for me. Working on changing that, and looking forward to developing my fabrication skill set in the near future.

Brenton

Hi,

Welcome to the group, there are several airplane guys here.

Bill

Welcome to the forum, Brenton.